Recent content by Jermc

My ebrake on the one side had at one point been stuck on, so it wore a ridge into the drum portion of the rotor which made it impossible to get off. I used the bolts in there and it cracked the rotor face. I got so fed up with it that I just cut the entire rotor in half with an angle grinder...

It will likely be the same as mine, there will have been water intrusion into your front wheel hubs where the ABS sensor is, causing rust which then sticks to the sensor. You can take the sensor out and clean it, but it will likely come back right away. The long term fix is to get your front...

Just a quick question, should I be locking out overdrive while towing an approximate 3500lb boat in my '05 sequoia?

Agreed.

Ya, you know, the webstore wasn't working properly the first time I looked at it and didn't add the extra expense of the swingouts or other options, so it looked like a better deal at first. It is at least in Canadian dollars though.

Coastal offroad just added this to their site, https://www.coastaloffroad.com/product-page/1st-gen-sequoia-high-clearance-rear-bumper-kit/ thoughts?

So all of a sudden I have a shaky idle, which is weird because up to now I could almost never tell the engine was running at all. So I went down a rabbit hole of possibilities, the first being either bad spark plugs, and/or a bad coil. However there were no codes present, and the engine seemed...

Good day, new member here, so this is my first post. I am in Calgary Alberta where we have access to some pretty good wheeling. I am currently looking for a 1st gen Sequoia to build up while also maintaining it as a daily driver.