02 Sequoia “Walt”

Mtoddsolomon

Active Member
Jun 11, 2019
34
4
8
38
I posted this on ih8mud but I’m hoping this forum is alive and well now.

I’ve been researching the sequoia builds on about every forum I can find since my father in law gave us his sequoia. It’s a 2002 Limited with 196k miles in the clock.

Since I’ve owned it I’ve replaced the following:

-brake rotors/pads
-stereo
-rear bumper
-front passenger fender
-plugs, coils, and o2 sensors (o2 sensors were cheap Chinese, replacing again with Denso)
-replaced both front seat leathers
-replaced rear hatch handle and window motor
-replaced driver window regulator

Parts in the garage:

OME 2.5” lift from 1st Gen offroad
Freedom Offroad UCAs from 1st gen Offroad
Maxi Trac awning from Napa
Pro comp street lock 16x8” black steel wheels.
Yaw rate sensor
OEM lower Ball Joint

Still to come
-Tires thinking ko2s
-JBA shorty headers (needed for tick and stuck o2 sensor)
-wheel bearings
-Sherpa rack
-ARB tundra bumper
-xbull winch
-either coastal Offroad bumper or rigd tire carrier
-100 series snorkel
 

Mtoddsolomon

Active Member
Jun 11, 2019
34
4
8
38
Big steps this weekend. Started installing the lift and tires yesterday.

Took longer than expected due to several trips to the auto parts store for rental tools.

I still need wheel spacers, because the wheels are rubbing the caliper. I also had to order new tires rod ends which will both be here Monday.

Rear install starts today..
 

Mtoddsolomon

Active Member
Jun 11, 2019
34
4
8
38
It took a little longer than expected. The issue being autozone didn’t have everything I needed as a loaner tool in one kit. After 3 trips to the store on the first side, the second side took 30 minutes

I did the lower ball joints, uca, new sway bar end links, and the ome 2.5” kit.

The wheels I got need some spacers for the front so they’ll clear the calipers. I’m also waiting for some new outer tie rod ends.