Recent content by smtx_sequoia

Sorry for the late response. i’m not going to lie to you. I went ahead and used a tapered drill bit and cut away some of the material so thatit would go in. And then i later replaced the tie rod ends.Haven’t had any problems since then.

I have a set of MB legacy wheels, i’ve only had them on about 2 months. They’re 17x8.5 -10 offset. Asking $600 OBO. Local only to San marcos tx area. Nothing wrong with them, just want to go with a different style wheel.

I just replaced mine on my 03. Everything matched up but the hole for the tie rod end is smaller than the old one. I ordered 43330-39466 & 43340-39356.

So i ordered 43340-39356 & 43330-39466. Checked on the toyota parts online and it says they fit my 03. I installed today and found out they do fit but the hole for the tie rod ends is smaller than the old ball joints. Has anyone had this issue before? Or did i get the wrong ones?

Ok thanks

I found a good deal on 2nd gen bull bar, but don’t want to buy until i know for sure it’ll fit my 1st gen. Did u find out if they fit?

New member and new toyota owner. We just picked up an 03 sequoia limited 2wd with 169k a cpl months ago. So far we love it. Had to put full tint on it since this tx heat aint no joke.