Hey thanks man! I would say that the measurements are close enough but I would recommend you to still do some quick measurements to verify that you are satisfied with them. Let me know if you need any physical measurements and I can try to get them to you in a timely manner.
Nice truck! You'll either have to get a rear bumper from somebody like Brute Force Fab or similar, build it yourself like others have done or I believe its called a Wilcox hitch setup that allows you to use your hitch to put it on the back.
Hey welcome to the forum. I'm not sure of how to extract it but I was going to say that the repair manual in a different thread in here will probably be able to tell you. The other step that I would check out is YouTube but check more on the Tundra side since it is more likely to have repair...
Cowling / Blower Fan Leak Fix
Duration: 1 hour
Materials needed:
Marine Silicone
M12 Socket
T20 Star Bit
Pliers
Did a little enhancement or fix to an old truck. I began to notice over the winter that when my blower fan for the A/C and heat was set on low it would tick like there was a card...
In between t4r and ih8mud and this site you will definitely find your answers. Also use tundrasolutions.com and find their 1st gen page. A lot of helpful posts int there.
No I understand. I never login to my FB account but I creep on the page now and then. It sucks because there were a lot of guys on here like the OP of this post who now only post on FB. Tundrasolutions and iH8Mud are two other locations where there are a lot of knowledgeable people.
But that's...
Honestly you would get a way quicker response from Jim if you went on the Sequoia Off-Road FB page. A lot of knowledgeable people don't post anymore on here and prefer to use FB as their medium which sucks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.